Running Wire In Attic

Do not drill them through the joists or rafters.

Running wire in attic.

The staple gun should be loaded with wire staples designed for holding the size and type of wire you are running. Once the hole is cut in the wall insert a drill bit to drill a hole so that you can run wires through it. Running wires inside rigid metal conduit rmc is a little more expensive than burying underground feeder cable uf but it saves labor. The attic wiring should be protected and secured to ceiling joists or other wood structural supports.

Yes this should be corrected and it would be good to have the wiring and all the circuit connections inspected as well. Drill a hole to run security camera wires from your house. If you can run it across by stapling it to the rafters you can avoid the insulation thing. Bring all of the wire up into the attic.

Keep the holes centered on the studs. The following links will assist you with your electrical question. The bottom of the floor joists you can run the wires through raceways that fasten to the bottom of the joists. The clips allow easy access if you need to run.

Remember to use a right angle drill with a hole saw bits for boring large holes. For the horizontal portion of the cable run this can involve drilling holes in the joists where the cable will pass. When adding or replacing wiring in finished walls most electricians will attempt to make the horizontal portion of the cable run in the unfinished attic or basement crawlspace areas looping the cable down or up through the wall cavity across the floor or ceiling joists then vertically through another stud cavity to the next wall box opening. After you ve run the wires through the clips you snap a plastic cover over the entire assembly.

While one person holds the flashlight the other person should use a staple gun to run the wire along the rafters from one entry hole to the other.